Monitor Audio Wireless link

The WT-1 can be used in conjunction with any AV receiver, source component or amplifier with LFE or stereo outputs. The units configured are stereo and can transmit full audio band stereo in a lossless, uncompressed format; therefore preserving the signal quality and integrity. A single LFE channel can be used for sub-woofer applications.

Decades of dealing with long, ugly cable runs can be consigned to history in minutes by installing our diminutive new WT-1/WR-1 wireless link. Measuring just 6cm round by 4cm deep, the WT-1 transmitter and WR-1 receiver establish an automatic lossless audio connection between analogue outputs and inputs over a range of up to 15 metres. The pairing is entirely intuitive and immediate: no elaborate button pushing is necessary.

Tucked out of the way behind equipment, the WT-1 transmitter simply plugs into the analogue LFE or pre-outputs on your AVR or player, and the WR-1 receiver into the inputs of a remote subwoofer or amp. The unobtrusive, ultra-compact modules then use the 2.4GHz digital band to send uncompressed full-range audio through the air between them. Effortless installation replaces long runs of ugly wire to wirelessly extend the power of our WS-10 active subwoofer, and enable full-range, wire-free performance and convenience in any set-up missing wireless functionality, but with idle analogue inputs and outputs.

Simple to set-up and easy to use and expand, Monitor Audio’s super-flexible system of active ASB-10 Sound-Bar, optional companion WS-10 active subwoofer and WT wireless link applies over four decades of award-winning audio precision to restore the sound you’re missing from your TV and help you complete the high definition AV experience in your home. Easy, dynamic and beautifully discreet.

• Digital 2.4GHz band
• ErP certified
• Analogue stereo inputs/outputs
• 20Hz frequency response

WT-1 and WR-1 are diminutive wireless transmitter and complementary receiver modules measuring just 6cm round by 4cm deep. They can be used together to create a simple wireless zone extension, or to enable wireless rear speakers in a home theatre system.

The WT-1 can be used in conjunction with the WS-10 subwoofer to create a wireless sub-woofer system for use with any AV receiver or amplifier with LFE or stereo outputs. The units configured are stereo and can transmit full audio band stereo in a lossless, uncompressed format; therefore preserving the signal quality and integrity. A single LFE channel can be used for sub-woofer applications.

This module is ultra-compact and can be hidden out of sight a the back of an equipment rack, amplifier or TV. Once the modules are switched on, they will automatically lock on to each other and connect. No buttons to press or pairing is required. The set up process could not be any simpler.

 A non-slip silicon rubber bass is designed to not mark or leave residue on surfaces. 

* WT1/WR1 are designed and approved to ErP standards and comply with Eco design for energy related products Regulations for Energy-Related Products Directive 2009/125/EC. This means the units consume less than 0.5Watts of power in standby mode.